This means the Edel had detected one of the following possible issues:
- Discrepancy between the air, water & evaporator temperatures
- The hot water or air temperature sensors might be misreading or accidentally swapped around
An engineer’s visit will be needed to establish root cause & repair.
Take following parts (applies to all sizes):
X-B1244575 (Hot water temp probe 10kOhm 1200mm)
X-B4993072 (Evap temp probe 10kOhm 900mm)
X-B1244090 (Air temp probe 10kOhm 460mm)
X-B1244096 Main PCB
Note: It is impossible to ask for the backup to run if there is an ERR02 fault as the hot water temperature is suspect and cannot be relied upon to control the immersion element.
Require additional help? Please follow link below
https://glendimplexservice.freshdesk.com/a/solutions/articles/79000136321
Applicable Models:
EDL170-520, EDL170-520RF, EDL200UK-630, EDL200UK-630RF, EDL270UK-630, EDL270UK-630RF
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article