How do I change the battery on my Quantum heater?

SERVICING AND REPAIRS

WARNING – Servicing and product repairs should only be undertaken by the manufacturers approved service agent or a similarly trained or qualified person, using only exact manufacturer approved spare parts.

This information is only applicable to Quantum heaters series G6/G7/G8/G9/G10/G11/G12/G13/G14/Y/Z

Follow the steps below:

1. Push a small, flat headed screwdriver into the opening on the right hand side of the User Interface (Fig. 1) to release the retention clip.

2. Lift the User Interface module out, away from the heater, being careful not to damage the cable

3. Unscrew the battery cover (Fig. 2) to gain access to the battery holder.

4. Use a small, flat headed screwdriver to remove the battery from the battery holder and replace the battery.

5. Replace the battery access cover.

6. Push the User Interface module back into place, again avoiding damage to the cable.

The Quantum storage heater is fitted with a replaceable CR2032 battery in the user interface. This battery controls the on-board clock to keep real time should the peak power supply be cut from the heater. This battery should work for approximately 5 years from the date of purchase.

Applicable models

QMRF – QM050RF, QM070RF, QM100RF, QM125RF, QM150RF

HSDHHR – HSDHHR050, HSDHHR070, HSDHHR100, HSDHHR125