UI= User interface
CC= Charge Controller
Series A - F
You need to change both UI & CC as the QMKIT1 (part number X-03/82985/0SP) so the software matches.
You cannot change just the CC or UI on its own.
Series G
You need to change both UI & CC as the QMKIT2 (part number X-03/82986/0SP) so the software matches.
You cannot change just the CC or UI on its own.
Series G5 / G6 / G7 / G8 / G9/ G10 / G12 / G13 / G14, Z & Y
You can change the UI on its own as long as the CC already says CC20 or CC:02 on screen:
If the CC shows CC:19 then it should be replaced by CC:20 (or CC:02) when changing the User Interface.
CC is part number 100000038
QM050RF User Interface = 300004431
QM070RF User Interface = 300004432
QM100RF User Interface = 300004433
QM125RF User Interface = 300004434
QM150RF User Interface = 300004435
Series G11 only
If you are changing the User Interface on a Series G11, you can leave the CC in place as it will already be on CC:20, but you MUST also change the fan X-02/80017/0SP and remove any fan speed dropper resistor which was in circuit.
CC is part number 100000038
QM050RF User Interface = 300004431
QM070RF User Interface = 300004432
QM100RF User Interface = 300004433
QM125RF User Interface = 300004434
QM150RF User Interface = 300004435
If changing the CC, but not the User Interface, the fan & resistor can remain in situ.
Applicable Models:
QM050 QM070 QM100 QM125 QM150 QM050RF QM070RF QM100RF QM125RF QM150RF
Require additional help? Please follow link below
https://glendimplexservice.freshdesk.com/a/solutions/articles/79000136321
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article